Search results

Posted awhile back about the Advantage lifts I saw at the Mecum auction in Florida. Did more research and decided to purchase one. Here are pics of the finished product. I assembled myself with help on putting the tracks in due to their length and weight. Instructions were good with many...

With all the options, it was about $500 cheaper than my other choice.

I bought a 1970 Oldsmobile 442 W-30 replica. I have a real w-30 engine and that is all it lacks. Simple swap and there it is.

Here's their link with pics of the lifts. http://www.advantagelifts.us

Was at the Mecum auction in Kissimmee, fl last week and saw the Advantage lift demo of their 4-post lift. It was impressive and compared very favorably with the bendpak 9,000 lb lift I had been looking at. They had a package deal that included a rolling jack tray, drip pans, ramps and casters. I...

12 gauge with either game load or 00 buckshot, depending on the varmit.

Built my carriage for an attic hoist. Angle iron frame, 3/4" plywood bed and a 4 sling bridle to lift it with. Great day with the welder.

Installed my hoist today. Used .25" metal plates bolted to the peak purlins as support for the 2.5" pipe which I used to hang the hoist from. I'm using the single line 500 lb capacity as I do not intend to lift anything over 200 lbs up there.

I bought one of the expensive LED floodlights for an outside security light. Supposed to last 20 years, burnt out after 1 summer of use. No more of them for me. Sent from my iPad using Tapatalk HD

Thanks, good info.

I want to install a lift in my shop and have read many of the threads but in doing so have conflicting information. I have the normal cracks running through my floor and some say you can't install a lift if there are cracks in the floor. Others say cracks are okay as long as the concrete is...

I used it in my 50 x 30 shop. Plumbed to all walls with two reels on opposite. Run small blast cabinet, all air tools, etc. like others have said it is hard to keep straight, make sure you straighten it out for a dew days before installing. Only problem I've had is small leaks at fittings...

In Bridgeport Texas, quoted me $400 for purchase of both tanks. The just change out and pay for gas.

Purchased a parts washer with a pump and need a good non-flammable solvent to run through it. Any ideas on a good cleaner for car parts to clean grease?

I have two stationary and one roll around cart 4 x 5 that's acts as a workbench while I'm working on my vehicles. Bet of both worlds.

My set has been okay with the torque limitations mentioned but the air hammer will no longer work after cutting one lug nut off. The ratchet has been great.

Can't wait, going to start mine with my bonus this year. Thanks for posting!

Roll ups are hard to keep insulation on and are much noisier than std garage doors.

Leve is right, the primary purpose of the pressure tank is to prevent constant cycling of the pump by controlling the pump with a pressure switch that only kicks the pump on at a preset pressure.

You can get these and many others at 1000bulbs.com