Search results

So Im going to purchase a new used box for the house. Place Im going to sells like new used snap on boxes. Im looking at a KRL1022 or a Epiq 68" with stainless power top. The price difference is 2k and the KRL doesnt have a top on it which I would want to get. So is the price is worth it to just...

Looking for some assistance with an issue I’m having with my door opener. It’s a craftsman opener from 1994 chain drive 1/2hp. It ate the Teflon gear so I replaced it. So what it does is it won’t close without holding the button and the light blinks like the safety sensors are bad. I tried...

This isn't my garage but figured someone here could help me diagnose this. So I built a walkin closet up into my attic space about 5 years ago. I insulated against the roof but used the styrofoam spacer stuff to give an airflow gap between the roof and the insulation. So it finally warmed up in...

So after my heater sits for awhile unused I get a god awful screeching from it. Sometimes it doesn't fire the first time either. I think its the gas valve not opening. Today was the first time i fired it since last year it tried to fire three times needed to reset it before i got this.. Have a...

So I just got a bunch of these 4' bulbs cheap. Anyone know what the difference would be make them work in a T12 fixture vs a T8?

So I have a pretty new craftsman door opener and the range on it ***** to where I almost need to be right in front of the door for it to work. I have an older one on my other door and that thing works from down the street. I would think that a new one work just as good if not better but its not...

On the board inside there is a terminal or a c-wire connection. Can i use it to power a wifi thermostat? I dont want to overload it if it cant handle the current a wifi thermostat needs.

So how far away from the corner would you mount the heater? So basically if just blows from corner to corner as i read the manual if its mounted on a 45. A few vent questions. Is the concentric kit worth the cost? I could do a single vent a whole lot cheaper and then do a pvc intake into the...

So I am installing my new beacon morris heater and questioning the placement. The ideal place in the corner of my garage is also where I have an oven I use for powder coating. The oven stands about 5' foot tall. Should I be concerned with the heat from oven and the heater hanging about 2' above...

I will Update this thread as progress moves forward. To start off my install I needed to bring a gas line out to my garage. So in the process I figured I add the conduits I needed while I was digging. I am using 1" or 1 1/2" to pull a through a 3/4" CSST gas line. I need to see if it pulls...

What material can you use to run a NG gas line from the house to the garage underground? is PVC ok? Or can you use that yellow flex stuff? I was thinking of running that flex stuff in PVC as a conduit.

I have been here for 10 years working on it. In between the honey do list haha!! Its 25x25. I have a lot of hobbies which include a car I always work on. I also powder coat as a side job out of it. The car 85 Z28

I'm looking to install a modine hot dawg heater in my shop/garage. I've seen a few different calculators and have read through tons of stuff and am still not set on a size. space is 25x25 8ft ceilings. R19 in ceiling and dry walled. Walls are bare block walls. Hoping to insulate in the future...