Search results

I am not a builder so I don't know how this would look or if possible. We are moving onto this house and I want to make the garage bigger. Is it possible to add about 10 feet to the front of this garage? How would the roofs connect if it is possible. Thanks. Todd

I need "okay I want" a good adjustable wrench for my work. Nothing over 6" long. My work provided me one but it is junk. What do you all like? Thanks Todd

We are looking to move. This is the garage at the house we are looking at. Based on what you see in these pictures Are there any red flags or concerns other than it's smaller than what I have now lol. Thanks Todd

We are putting led recessed lighting in a living room. The room is only 20'x12'. Trying to figure out the spacing of the lights in the ceiling. How far away from the wall should they be and how far apart should each light be from each other? I'm thinking of putting six 6" lights in the...

Is it safe to run a bare copper ground through metal conduit for a 240volt hookup about 15 feet from a sub panel to a AC disconnect?

I have this older, non- ball bearing slides, 18" deep bottom and 12" top Craftsman tool chest set I no longer need or have room for. It has some surface rust on one corner of the lid. I don't want to sell it as it cost me nothing when I received it. (No it's not stolen) Any suggestions what I...

Is there such a thing as a garage door monitoring system that does not use wifi? I don't have wifi and don't intend to get it. Todd

I am looking for a manual hole punch set(hit with a hammer kind) to make holes of different sizes in thin rubber, cork, plastic, leather etc. In the past I used spent bullet shells but they don't last long and not the correct size. The hand ones that you squeeze with the wheel are junk. I am...

Garage is detached 24'Wx30'Lx8.5'H. Ceiling is covered with .5" OSB and walls are 2x4 construction and has fiberglass insulation in walls and ceiling. Walls are covered with pegboard. R12 insulated 16'x7' garage door and 2 fiberglass 36" insulated man doors on side and back wall. RaceDeck solid...

Opinions on this for my fully insulated 24 by 30 ft garage. Will it keep it around 55 degrees F? I am in Michigan so it gets very cold here. Thanks Todd

I have some headlights with LED halos that I am not using in my car. I want to install some headlight buckets and install the headlights in the wall of my garage above my man door. I want only the LED halo lights to come on the headlights when I turn the lights on in the garage. My question is...

What sealant should I use under the threshold when I installed a new man door in my garage? The threshold will be sitting on cement. Should I still use threshold tape even though it's going on cement? Thanks Todd

I will reach out to RaceDeck also but want to ask here also. I installed RaceDeck solid XL diamond in my garage in 2017 The first two rows are Freeflow XL for drips off the main door. Now I would like to install Freeflow just wear the tires role on the daily drivers. My question is, does the...

I have a 20 plus year old concrete driveway.(30'w taper to road to about 16' x 60' long). It's in relatively good shape except for some minor cracks and and small holes. There are no missing pieces etc.. I am looking to get it resurfaced professionally. Has anyone had this done and been happy...

I am getting a new Clopay 16'x7' steel garage door from a independent door installer that has been around for a long time in my area. It's insulated and has steel on both sides. My question is will I need to install the struts on the back to keep it from bowing when up and help with high winds...

I have been on here for about 5 years and just joined. I really enjoy everything about the sight (even learning the new format) and all the information provided. I will post pictures of my garage as soon as I am aloud. My garage is 24' x 30' detached. Racedeck flooring and white pegboard...