Search results

https://www.digikey.com/en/products/detail/c-k/7301SYZQE/7080?gclsrc=aw.ds&gad_source=1&gad_campaignid=20243136172&gbraid=0AAAAADrbLlh8qokGP2OX2TllMeo70F18D&gclid=CjwKCAjwyOzSBhBTEiwAmxvJ-qqZtwEU--k5yNhCzBXod7DqwfhED3I3BfGSSgUsL_JyKjXoBrhzdhoC4LsQAvD_BwE

Trusty companion always by my side.

What is the device on top of the light? Maybe old converter to make opener compatible with newer style remote controls? Auto door closer?

Assuming its plugged in on other side of outlet my guess would be a transformer / low voltage power supply of some sort. Do you have any low voltage lights etc outside garage? Maybe for old telecom equipment or alarm? Dog fence (underground wire/ collar system)?

I passed on the Walabot and ordered a Bosch. I also ordered a FINRSI and CH Hansen magnetic stud finder. The FINRSI was more of a curiosity because I recently picked up a DMM and portable Oscilloscope and was impressed. The stud finder was only $35 so figured I'd give it a shot and see how it...

The US military was at the show! I just sent an email to vendor will see what they say. Hopefully will correct for future shows. I said they need to get the flag right esp for show celebrating USA 250th.

Town put on a 250th event couple days ago. West Point band followed by a drone show. All and all it was a pretty good show but I was immediately put off that they got the flag wrong. I said to my wife the drones have to be from CHYNA lol.

I just got a project to do kitchens and baths in a couple of apartments that a friend recently bought. The apartments are in an older multi-story building and am concerned about causing any damage behind wall so thinking about ordering a Walabot. Read some more reviews and watched some more...

Funny the garage door opener that I repaired was an Access Master but believe its made by Lift Master. Different control board though. Similar issue. As far as OP is concerned I don't believe physical size differences will matter the two caps should be identical from an electrical standpoint.

Are you saying the replacement cap caused your control board to fail or that the run cap was not the issue? I recently went through this with a garage door opener. Thought problem might have been the cap but tested it and it was in spec. Control board was the problem. It was actually...

I usually run a bit of denatured alcohol through pump and hoses of brake bleeder and also in oil pans after using them.

Nice call on Wudel. There is write-up here. https://stock.corvair.org/wordpress/2024/05/corvair-power-train-installation-and-removal-tools/

Same spec made in different facilities could just be how tooling in facility was configured. Film windings may be short and wide in one but long and narrow in the other. Could have different oil contents. One is made in China the other is made in USA. Either one will work if it fits in your...

Does trailer have electric brakes or need auxiliary power? Is it a camper? I'd leave it and buy an adapter...

Recently bought a motive pressure bleeder and it says the cap that I bought for my Ford will work. https://www.motiveproducts.com/products/1107-ford-asian-import-3-prong-adapter?srsltid=AfmBOooebJ12A_HE1XBpNTu304S2tDc4QhoP-tcVQZxyFX62ZKYGr_Zq

Agree with you except I believe that drop style handle is an Accu Fence not Biesemeyer. It doesn't have the UHMW plastic side plates though and no rule or slide surfaces on the beam is dead give away that its fake. Missed that before. So obviously a fake but with so many good saw pics on the...

Huh. Scary. OK I agree the scuff/paint on the floor is the same too.

Edited - Nvm

I have same saw its awesome.

So put everything back together and garage door started to lift about a foot off ground and then carriage returned about six inches and stopped. It was stuck partially opened in a 6 inch cycle. Figured it was a problem with either the travel limit screws or the up or down strength adjustments...