Search results

.voris hydraulics springfield mo has two complete parts jacks and nos stuff as well. 417.869.7933

also... that release stem IS the overload also. in your last picture the distance between the packing nut and the ajustment nut. a quick measurement with calipers will let you re-sit this to original. when you get the unit apart look into the bore for the piston very carefully. they are pitted...

Walmart super tech brakeclean/ carb cleaner works very well. takes paint and nearly everything else. A couple of machine shops here keep the stock low so getting any kind of hit and miss..... WORKS GREAT AT 99 CENTS A CAN HERE. i also use it for gun cleaningbefore hoppys and new oil.

you have my vote!!!

love it... get your moneys worth!!!

mine looks a lot older. forgiving units arnt they

In a former life... EA6B was covered with panelswith 10/32 screws an inch apart. no air or electric of any kind. that speeder was your best frend

Voris hydraulic in Springfield Mo. We keep the kits in stock and a good rebuild should last 20+ years. The jack is worth it. we only need the unit.

Be very nice to the forward nut that holds the fluid tank tight. over 400 foot pound of torque and that nut is getting hard to find

It Is a weaver Looks to be a 4 or 10 ton. on a first look a 10 ton has loadwheels that are almost 6 inches tall. Easy jack to repair. when ordering a kit pay attention to the pump shaft size. they did make some changes along the wayWeaver STILL builds that jack and it still looks the same!

Porter Ferguson. VERY HIGH QUALITY.

fresh kits in stock

Voris hyd. Springfield Mo 417.869.7933

Those plugs with the large straight slot are in tight! You need a hand impact driver. 3/8 drive with the bits is the normal for moving them. the tube will have several hundred foot pounds of torque on it,,, takes about 5 feet od cheater pipe to break it loose. will need that kind of torque to...

Bleeding the air motor is fun. the 1 inch stem out of the large tube has a 1/8 pipe plug set screw in the end near the castor wheel. with the set screw removed i place my finger over the hole and run the air motor slowly. It should **** fluid out of the unit and then want to push it out past...

That white air piston is very expensive.there is a "trip" spring on the 1/4 inch rod that is in between two large flat washers.that spring can break now and then. would not call it often. next there needs to be a rubber pad on the spirol spring on the back side of the air piston. This rubber pad...

American made bottle jack can still be bought Look for "US JACK" Not cheap but they have been build the same for a very long time and kits are no problem

that is going to be a fun one. the release is badly worn over time. the fluid has almost gelled and the gland packings are shot. well worth fixing! getting the nut off of the tank will be the hardest part. two slots in it are for removal. please do not use a pipe wrench to remove it. that nut...

One thing to check out,Cornwell does warrenty torque wrenches forever. Local dealer said no. I called the factory number and explained that I wanted mine re-calabrated. no problem no bill. I did explain that if it could not be repaired I did want it back rather than replaceing it. the ratchet...

Norco still has the kits. as of last week but there will be no more when they are gone.