Which Pass Thru/Go Through Sockets/Ratchets Swap/Interchange?

[retDAC]

Adding some knowledge to this database thread. I realize it's an old thread, but it is very detailed. I went ahead and purchased a GW 893823

The length of the ratchet at 12" is accurate. The ratchet is ~ 11.7 mm in overall thickness at head, not including the directional switch.
10 mm, 11 mm, 12 mm, 13 mm, 14 mm, 15 mm, 16 mm, 17 mm, 3/8 ", 7/16 ", 1/2 ", 9/16 ", 5/8 ", 11/16 " are ~ 32.0 mm in overall height.
18 mm is ~ 32.4 mm in overall height.
19 mm, 3/4 " is ~ 33.0 mm in overall height.
13/16 " is ~ 34.7 mm in overall height
7/8" is ~ 35.1 mm in overall height.

Thanks for the measurements. Every once in a while somebody needs them.

 

[YoshiMoshi3]

Thanks for the measurements. Every once in a while somebody needs them.

No problem. Can you list the specs for your pass through set?

 

[bob from indiana]

Has anyone tried the newer Klein pass thru to see it it is comparable with anything?

 

[Ohio Andy]

Has anyone tried the newer Klein pass thru to see it it is comparable with anything?

So you mean the Klein knect?

 

[GeoBruin]

So you mean the Klein knect?

So what's the pattern/size of the external drive? Looks like 12 point?

 

[Ohio Andy]

So what's the pattern/size of the external drive? Looks like 12 point?

On this set, everything is 6 point.

1/4" - 9/16"
7mm - 14mm

 

[GeoBruin]

On this set, everything is 6 point.

1/4" - 9/16"
7mm - 14mm

Sorry, I'm talking about the external drive interface, not the hex where the fastener goes.

 

[Ohio Andy]

Sorry, I'm talking about the external drive interface, not the hex where the fastener goes.

Oh yes, sorry 12 point...

I was able to stick the socket quite handily into a 13 mm socket and also into a 1/2-in socket with no problem. And by that I mean a 12 point socket.

Also, an mt14 triple square fit into the ratchet itself... But that was a really sloppy fit.



Notice the detent, that holds that socket pretty firmly into the wrench