Recent content by warrent

Not sure why you say they stink so much. Only time you get a little odor is when you shut them down. Just have to make sure they are adjusted properly., I have been running 2 32k BTU for the last ten years in my un-insulated 21/2 car garage. Once it gets up to 50 degrees I shut one off. If...

tap tap tap tap tap tap tap tap tap tap tap tap tap tap. Sounds like a dog with long toe nails walking on a vinyl floor.

RPH. just to clear up the "Headlee Admendment" is to do with the millage rate set up by the local goverment. Propostion "A" has to do with how much the taxes can increase per inflation or the increase in land value. Max 5% a year. Two completely different things. NW, did you ever report the...

On the fire extinguishers the best place to mount them is by the exit doors. Remember the first thing to do when there is a fire is run for the door. So by putting the extinguisher there you will always know the location. Just a simple safety tip is to remove the drill bit from an electric...

If you contact a local janitorial supply and ask for an emulsion degreaser. These will brake down the grease and oil. Around $16.00 a gallon. You may have to let it set overnight but just power wash off and should take most of the grease away.

You should not really clean an anvil. If you use it, the top will remain shiney along with the horn. If anything just take a hand wire brush and knock off the loose stuff. Painting is a waste of time because the hot slag will burn off the paint. Also remember an anvil is to be used with hot...

Ben, You might want to check with some of the knifemaking sites. I know some of those use that type of belt, or maybe try Metal Artist Forum. I would just like to find something simple like the 2" hook and loop sanding disc that fit on the Harbor Freight new little DA air sander.

Thanks, I am looking to put something in the basement (yeah I know) and just wondered how it feels with the textures.

Quick question for the floors with the textures, round dots or whatever, how does it feel on the bare feet? Also is it harder to slide things around with the textures?

Yeah your whole bench top could use some space saving. Put the keyboard in a drawer in a tray, hang the monitor on the wall and PC in the cabinet. Also way too many stools specially when they are stacked up against the wall. Hang them from the ceiling or on the wall when not in use. But...

Back of the neck is frying and your nose is running because it is so cold.

On the brass knobs, depends on the coating but try a paint stripper first to remove the old finish. (Sanding you will make it too sanded of finish and will take for ever to get shiny again) If you want polish then polish, problem arises that you have to remove the polishing residue....then you...

Good vise grips from VISEGRIP brand. Flat jaws and round jaws, couple of different sizes. C-clamps.......HF will work for most stuff but a little shallow.

ws6, you say from the compressor discharge? Just for what it is worth I would not use standard rubber hose or hydraulic hose. Even though a little expensive, if coming off of the compressor because of the heat you might want to look at a teflon lined hose. Something like one of these...

Well not sure where to go on this. Some brands have tools that I really like. So I have a mixed bunch. I pulled wrenches for over twenty five years so you get a little taste. I love my MAC 1/2" long handle ratchet, tough ****** even with a 4 foot cheater pipe. The 3/8 MAC is so so. The box...