Recent content by WhyMe

which one works better? I have been using blue loctite for many years. found something recently name vibratite VC3. Supposed to do the same thing as loctite, but can be removed and moved as needed. So is this Vibra tite stuff as good as they advertise?

one of the things i have noticed in the kits is that the safety seal one has a extra peice on the inserter to protect your hands or assist in insertion. Does the lack of this in the balck jack one matter?

where are those 44 people when i have a flat tire on the side of the road??:lol::p

i have one and did my Subaru with it. make sure you get the one with the one piece screw. you can tell as the older ones seem to have weld where the bolt head is. it worked ok, but it does not come with a hub removal tool like the nicer models, nor the bearing race remover. a slide hammer can...

Gonna splurge and buy a nice tire plugging kit. Seems the 2 most highly rated are the Blackjack ones and Safety Seal. So which one should I get ?

i just went through this same thing with a Crewline breaker bar that I bought at Schucks, which was taken over by oriellys years ago. I called the local store and politely asked them what can be done and the manager told me" no reciept,no exchange". So I called the CS number and talked about the...

if you were going to get a cordless 4 tool set, what would you pick to be in it?? Drill? impact? other?

sorly, my Engrish not too goot. I apoligize for my bad spelling. Sincerely, Wi tu lo

http://seattle.craigslist.org/tac/tls/3953689409.html

One of the much wanted things I would like to have is a tire machine and balancer. I know they are expensive, but i would try to offset it by doing peoples tires. So anyone have a set at home?? was it worth the cost and do you use it often?

since you have all the needed sensors and stuff already wired in, i would just buy a self install one, hook it up to the existing sensors, program it and go. Programming it is the hardest part for a first timer. Monitored or not? I would go with not as the response times are usually pretty...

my vise has serrated jaws. I wish to use it for adjusting and installing pistol sights. Of course i prefer the slide not to have teeth marks on them, so what does GJ recommend for non marking jaws?

i used screw around the perimeter so I can change it out when it gets worn, which might be a long time. Or you can glue it down. if its good and durable enough to be a floor, it should not have too much problem as a bench surface

looks to be a HW. If i did not have 3 jacks already, i would be all over it http://seattle.craigslist.org/tac/tls/3958767591.html

If your intent is long term in your building, I would have power pulled. You can use that power to run containers and reefers and write it off also.