Search results

Anyone have one of the 2 ton blue and yellow shop cranes and replace the casters? The bolt hole pattern is 3” x 1 1/4” and everything I find online is 3” x 1 3/4”. Thanks, Rich

I have a metal NEMA 4x4 channel connected to a sub panel with rigid conduit. it has an L6-30, a 20 amp 220 and two 110v outlets. Because the box is grounded by the conduit, is the neutral on the 220's crossing the neutral and ground by being screwed to the box? Thanks, Rich

I've got 2 feet of the 4"x4" wireway with the cover. I'm going to put 3 220 (a 50AMP, 30amp L6 and a 20) plus 2 110v outlets. The cover piece is plain with the screws around the perimeter. Can I just mill holes for the outlets to stick through and not use additional individual covers? The...

Not sure where it came from though the mice liked the box. It doesn't have the bars on the outside for the ground and neutral. Can it still be used? They're together. Thanks, Rich

A Milwaukee M12 2311-21 inspection camera arrived yesterday and the battery with it fits but both the small and large battery from my M12 drill/driver combo doesn't push in all the way. They look the same, but I haven't started measuring on a surface plate yet. Aren't they all supposed to be...

I picked up at an auction and have wanted to get going. It's a 4SF40GH1 The diagram online shows a By-pass inlet right next to the pump inlet. The brass part and spring below were screwed into it. I think the other piece on the right was too, but was loose and fell out. The top part in the...

Picked up a project pressure washer. No hose or wand and didn't run. Has a Honda GX390 13HP and a CAT S4F 4GMP pump. Put a new carb on it and started on second pull and ran OK. The motor manual talks about adjusting the idle. Can you adjust idle with the pump on? Seems like it's full out or off...

Wagner 1075. When I bought sprayed some water through it. Don't think it's been touched in 10 years though. I unscrewed the hose (where the arrow's pointing) and it just tricked out. Don't have a manual but there only prime and pressure knobs to play with. Do I need to take apart and...

Broke down last week and ordered one for $99 off da bay. Wasn't really expecting as heavy or solid as it is. Passed on the miter attachment. Does one really need a ply top on one? Seems like angle iron would be enough if fitted to the saw that will sit on it. Arms for rollers could be 1" square...