Search results

I want to replace these 200,000 candle power (only know this from owners manual) halogen lights with 30-watt LED cubes and would love to know the wattage of the halogens. Any ideas? I didn’t pull the bulb but couldn’t see any identifier on it. Thanks

Hey guys, I ordered this beehive style drain for my Kohler Branham urinal and I’m not sure what to use to fill the gap around the PVC. Thanks!

Hey guys, My lighting layout calls for three IBE12LMVOLT40K fixtures at the peak in one side. I'm running a radiant tube heater at the peak so this isn't possible. I wired the barn for six lights in the peak (three sets of two on each side of the heater) but the electrical supplier I used for...

This guy went from working perfect one minute to do this: Any idea what I need to check? Thanks

Hey guys- is it a big deal to connect an ecobee/nest type thermostat to a new radiant tube heater? (I haven’t made up my mind on brand yet) Running wire right now for lights, ceiling fans, and heater and curious if i should run some low voltage thermostat wire or if you can only use those...

Hey guys I need a 230-volt air compressor for my residential hobby barn. 75% of it’s use will be filling tires on my truck & trailers, will run the occasional pneumatic tool. I want it to last but would like to keep it under $1k. Thanks for the help!!!!

I’m going to run cat6 to my barn from my router in the house to a router out there. It’s going to be a 300’ run. I know I need direct bury but what other “options” do I need? I know nothing about IT/network stuff. Thanks

Hey guys- I'm running 225' for a new 200 amp service. Just going to dig a trench and direct bury. Thanks!

It’s part of the wiring harness for my daughters 6-Volt power wheel. The little connector snapped off so just want to buy a different resistor/capacitor/diode whatever the hell it is. If it comes down to it I could try to solder it back together...

Hey guys I'm looking for a soffit can style light but would like it to shine straight down even though they'll be in the gable end of the barn. Does anything like this exist? Thanks

Hey guys, I’m preparing grade beams and need to bend some rebar. I’ve never done this before and only need to do it for the grade beams so don’t want to invest a lot of money. Does anyone have any good ideas for bending 90 degree angles? Thanks!!!

Planning a barn w/ high ceilings for a lift and curious if I should run conduit in the floor to power the lift for a cleaner look. Most lifts that I've seen run a drop from the ceiling. Just curious to get your 2 cents. thanks

Hey guys- Getting final prints ready for Structural Engineer (lakefront w/ soft soil so barn will be built on helical pilings) and want to make sure two post lift is properly positioned. Does anyone have (or know where to find) dimensions for 9/12 pitch scissor trusses? Thanks!!!

Hey guys- I'm getting ready to start clearing trees for my new barn and I'm not real sure about soil. What tests could I have done that will tell me if helical piles are necessary? If they are I'm considering just pouring footings on top of the pilings and going stick built. Thanks

Hey guys- I have a three car attached garage that doesn't have floor drains (the only part about the house that I don't love). Anyway the garage floor is sloped towards the overhead doors but it still nasty as hell and salt infused water pools where I don't want it. Are there any good options...

Hey guys I've been saving for this barn and just curious what the shell and concrete will run. I will do two dormers on one side vs the long window. Please include labor as im planning on only doing the inside (plumbing, electrical, insulation, etc). The trusses where the dormers are will be...