Search results

Thanks very much for clarifying.

Doesn't UL fall under NRTL? Why wouldn't a UL listed contactor be acceptable?

I am putting together a Frankenstein compressor with a Leeson 5hp (20.8FLA) single phase motor. The motor has a thermal overload reset on it. Read plenty of threads recommending a mag starter over only running a pressure switch. Can I mount a 2 pole contactor in a junction box and have it...

Thank you for making my point. Unless he wants to make the investment in all of that, then this will all be fruitless. Better off buying a bunch of $4 shear pins or the grade 8 bolt and new gear box. Not trying to reverse engineer a shear pin with no data.

You need to find out what amount of force causes your particular shear bolts to yield. Then you can reverse engineer the grade of bolt and depth to cut the notches. Unless you know what you are starting with then you are shooting blind.

Will a Snap On EETA308A low amp clamp measure AC current as well as DC?

https://shop.snapon.com/categories/Bleeder-Wrenches/675713

I have an 87v that can do the inline amp measurement. Just won't be able to graph it. Thanks for the info!

Got the vantage ultra this morning.

Any downside to the amp clamp over the inline?

I'm looking to get my first scope. The two I am deciding between are a Vantage Pro with set of leads and version 9.4 or a Vantage Ultra with leads and the optional low amp clamp with version 14.4. I see many people gravitate towards the vantage pro for a dedicated scope, is there any reason to...

Mine were good for 1-2 years of occasional light use. They started flinging snap rings across the room and finally broke a couple of the tips. I got the Snap On SRPCR112 to replace them.

Gentex. Far less "falses" than kidde and first alert. I have GN-503's in my house.

I did check them out. The deterrent was no phone number to call to answer questions. The Micro Air folks, answered the phone, answered my questions beyond any reasonable expectation. Then went on to ask about my setup, made suggestions, etc. Today it is so rare to find customer support folks...

I spoke with the folks at Micro Air this morning. They spent 30min on the phone explaining the how and why to me. Their attention to detail on the phone was exceptional and have no doubt if I need anything they will be sure to help out. I placed my order but unfortunately won't get a chance...

What is the difference between what I installed and what you are recommending? I'm not an engineer, would just like to understand the difference in how it is functioning.

OEM Recommended BAYKSKT260

Situation: I have a generator inlet and an EU7000is generator (5500 running 7500 surge) that replaced a slightly larger albeit much louder Generac. Generator is for emergency backup only. This past summer we used it during a very hot week and it had trouble kicking on the central air...

https://www.garagejournal.com/forum/showthread.php?t=446688 I've since found a local supplier which is cheaper for me due to no shipping.

SOLD SOLD SOLD KRL 1003 Has upgraded casters and locks. Has some scratches and wear but nothing major. The locker in the edge of the photo is not for sale Can deliver if you're local Asking $3500 obo