Search results

In my 14' ceiling shop by the heater hangs a couple feet from ceiling. I would have gone a little higher but the venting worked out better at that height Sent from my ONEPLUS A3000 using Tapatalk

Emt is easy. Precut them and go to town. Mine are 4' apart so required the hanger Sent from my ONEPLUS A3000 using Tapatalk

I'd mount the first fixture, then connect pipe, then next fixture, etc and build as you go. You could use compression fittings and add pipe later but that would be more work then just doing it as you go along. I used conduit standoff straps to hold the pipe between fixtures, helps during the...

I'd caulk it if it were mine Sent from my ONEPLUS A3000 using Tapatalk

I just cut my thimble to fit in the flat. It was only about 1/2" of each side Sent from my ONEPLUS A3000 using Tapatalk

I have both the diva and maxlite fixtures. The diva is more of a traditional t8 fixture with ends that can be used to connect to each other by sliding into grooves. It also leaves the connection between fixtures wide open. The maxlite fixture must be connected end to end with a ****** through a...

Great, thank you!! Sent from my ONEPLUS A3000 using Tapatalk

Excellent thank you! And wow, that is alot of fixtures! Any recommendation about instead going with the often recommended 110/165w James high bay led instead? Sent from my ONEPLUS A3000 using Tapatalk

Ceiling is flat Sent from my ONEPLUS A3000 using Tapatalk

Done

Adding larger image

I'm looking for lighting input on my 40x56x14 shed with white liner panel on the ceiling and walls. Drawing attached showing door locations and future lift placements (2 post first, then 4 post). After following the "best fixture ever" thread, I'm considering the 4' LED strip lights or the 2'...

That's the 40' side Sent from my ONEPLUS A3000 using Tapatalk

I don't have plans handy but I can get them from my office tomorrow. It's a pretty straightforward space. Do you want door layouts on a sketch? Best I have on me is exterior renders. 12x12 garage doors, 2 in front and 1 in back. 3' spacing between them Sent from my ONEPLUS A3000 using Tapatalk

Thanks for this thread and all the great detail in lighting fixtures. My new build is 40x56, 14' ceilings. Walls and ceiling will be white liner panel, no windows other than a strip in each of the 3 - 12' garage doors. I'm ready for lights and was thinking 4 rows of the LED strip (12 in each...

You could try this https://shop.ecobee.com/products/ecobee3 and use the remote thermostat you put upstairs to run the unit Sent from my ONEPLUS A3000 using Tapatalk

I watched my plumber dangle it in front of a portable kerosene heater. Seemed to work good and didn't take much heat to the pipe Sent from my A0001 using Tapatalk

I'm having mine built with single bubble under the roof steel for condensation control but not on the sides. I'm doing tyvek and will insulate normally with vapor barrier. Some builders here use dripstop adhered to the roof steel underside too. Sent from my A0001 using Tapatalk

With my joystick controls float is the right stick all the way forward. I would also travel parallel to the building while you work. Don't worry about getting it smooth in a few passes, it can take a bunch to work it Sent from my A0001 using Tapatalk