Search results

I have a true craft ratchet purchased in the early 80s. It was used once at that time for a home project, and has been sitting in the toolbox since. It is in excellent condition. 32 dollars shipped to lower 48 Bluepoint hammer with interchangeable heads. Also in good to excellent condition, 55...

I have a gray mills parts washer that has an air leak on this fitting, what is this called, and how does it work? Is it some type of compression fitting? Thanks Sent from my iPhone using Tapatalk

I was checking out some pro America pliers on eBay, and got a laugh out of their add "Pro-America Kal Tool Enterprise manufacturing state-of-the-art priers for over 50 Years! Competitive prices and American Made! Superior Quality! Made in USA! "

What kind of set up are you guys using for mapp gas? I have a simple propane torch at present but would like to upgrade Sent from my iPhone using Tapatalk

I have some snap on pullers purchased recently, looks like they have been in storage for many years, and never used. I think they are zinc coated or maybe galvanized . The surface looks chalky... any way to restore the finish ? Thx Sent from my iPhone using Tapatalk

I finally got around to organizing all the punches and chisels accumulated over the years... this is the snap on kit for KRL Sent from my iPhone using Tapatalk

Hello what is the correct orientation for the ratchet selector? It is placed in the head of the ratchet in the photo. Not sure which direction is supposed to point before the lever is pressed in..thanks Sent from my iPhone using Tapatalk

I have a couple of KRL boxes I'm going to put new locks on. I know how to get the locks off with the key, but one of the boxes doesn't have a key. Any way to get it out without having to drill it? Thx

How do you remove the thin chrome trim on the front of the drawer pull without tearing it up? Is there a special tool for this? thx

Anyone had a vinyl wrap done on their toolbox? How much did it cost you? How does it hold up? Is it easy to remove if you get tired of it? Thx

What's a good drawer liner to use. I have a krl722, and ordered about 5 roles of raptor liner on eBay ... I don't recommend this to anyone... The skin of it was peeling off in patches when I undid the roles, and I worked around it, but after 6 months I took out a heavy c clamp that had been in...

What kind of air saw blade would be best for cutting 7 inch diameter holes in sheet metal?

Is anyone familar with these? pros and cons? thanks http://www.flexzilla.com/air/high-flow-couplers-plugs/

I'm looking for a sandblasting cabinet.. What's the pros and cons of side load vs clamshell? Any other features to taken into consideration ? Thanks Sent from my iPhone using Tapatalk

I'm looking at using a hydraulic hose for my compressor whip. The ones I have seen have two male ends. What kind of fitting is used on one end of the hose so it doesn't twist when tightening up the ends ? thanks

Hello, looking for an aloris axa tool post and tool holders thanks

I'm getting ready to plumb out my compressor. Copper lines are already installed in the garage. The plumb out will be: Compressor ----filter ----air dryer ---- into existing system. I would like to have custom lengths to keep things neat. Would a rapidair kit work for this, or would...

which comes first in line out of the compressor, oil coalescer or water/particle filter, or does it make a difference? They will be mounted together.

I have an air dryer for my compressor. Would you put the filter before the dryer or after? It seems like it would be best to go before the dryer, however there will be a lot of water filtered, it will have to be drained. Where as after the dryer there shouldn't be any water Sent from my...

What's a good brand with flow adjustment for the air tool handle? Thanks. Sent from my iPhone using Tapatalk