Search results

Is OSB a suitable underlay vs plywood for flooring? If I intend to use vinyl flooring products will OSB work?

I have picked up 12 of those for shop lighting. 1 Costco had them with pull chains the other Costco had not chains. For the cost they look like a good deal and the light is good

sberry, noted. It appears that while it can be done going with properly designed materials is a lot easier. And I acknowledge that i do collect junk and try to cobble it together.

Plenty of room on the panel. I need a dedicated circuit? It is about 50' going up and across the ceiling or around the wall. what size dp breaker? can it run on 12 guage, I have plenty due to that is what I am wiring the shop with.

My idea was to use it to ventilate a shop building. Get the welding smoke out. I wanted to make a frame and mount it in a window (about 10' up) and switch it to use when desired. Back to original question... the window is on opposite side of bld from breaker box. If it needs to use 2 spaces...

It is an Emerson Mod #F48DZP-2106, volt 230, RPM 1550, HZ 60/50,, amp 1.5, HP 1/12. Hopefully this picture is readable

bump

Hopefully this upload of the motor works

I have a fan that I pulled out of an old 3 phase welder a while back. the plate on it indicates that it is 220 and there are 2 wires to power it up. They look like 16 gauge. My thought was to use it as a vent fan in the wall or temporarily in a window hole. Is this possible? Can it be run on...

Wylie that is 3 wire plus the ground. So this next ground wire goes from the same bar as the incoming ground is attached to?

When we installed the electrical panel in a shop that I am building the electrician instructed me to place a piece of rebar into the footing and ground the box to it. Where do I tie into the box with this and what size wire? The box has a 200 amp breaker but is supplied by a 100 amp breaker...

I placed 2 vertical pieces of rebar and tied 2 horizontal pieces between them. 1 right a the slab and the other about 24' up. Tied the pex to each horizontal piece paired up so I could easily identify the loops.

Badger what do you mean by; First, the proper Manual 'J' heat load to get the right output regardless of source or fuel.

That is why electricians have an apprentice with them; "see if that is hot boy"

I have a 6" slab with the tubes stapled to the foam. I figure that I can safely drill and set red heads or anchors at 4".

Compact base and wet it while compacting it. Put down vapor barrier, then insulation panels, staple pex to insulation panels. install mesh &/or rebar. Use chairs if you got the $$ or just 2X4 wood blocks to lift steel up into the mud. PEX is on the panels and steel is supposed to be in the...

I have read all of this but really would like to ask if a water heater can be used to get heat as efficiently as a boiler. It will have to be an electric water heater. Or a fuel fired boiler. I am ready to install my heat source before winter. it is in a 32' X 32' shop with 16' walls.

how is dry borax applied?

I need to paint the exterior of a building. The material is T1-11 and it has been up for 1 year without any treatment. There is a bit of black mold on the siding that I plan on spraying with a bleach solution prior to paint.. How strong a bleach mixture is recommended?

With all the $$ you are spending to do this why cheapout on a couple of hundred bucks for the foam? Spend the money and do it correctly and insulate under the slab