Search results

When using Heating Tapes on PVC Piping should the sensor be tucked in side of the insulation or left out exposed to the temperature ? Thanks Bob

I am familiar with P V C pipe but have never worked with C P V C, My question is PVC is for cold water and CPVC is for hot water, Right ? Next, what color cleaner & glue, any other tips about working with CPVC would be helpful !!! thanks Bob

Looking at one at LOWES, Spirit washer 3100 Psi with a Honda engine, Any one have one of these and your opinions of them PLEASE !!!

I have an old lake cottage that was built in the late 1960's with an unknown tile on the ceiling, My question is : Is there some kind of TEST to see if it is ASBESTOs ( sorry for the spelling ) the tiles are pure white and about 8" square, I want to replace it with a barn wood material, the...

In my house I have an addition which use to be the main building, in this part there is an old fuse panel box my question is can this fuse box be swapped out with a circuit box of the same size ( 100 Amp )

Silly question here but here goes... I just bought the house and I have several switches and can't find out what they go to is there anyway to check out this problem???? I turn on/off the wall switch and nothing lights up any way to tell what these switches control ???? thanks Bob

What do I buy? Usually I am just driving screws, so what do I want a drill or an Driver ????? thanks Bob

Greetings! I have an 18 volts P.C. drill that the chuck has gone screwy, do they have these at Lowes and how do I change it ? thanks Bob

Craftsman 10" table saw, I cannot adjust the tension in the fence, as I try it will not stay secure I must use a C clamp on the discharge end of the fence, any ideas how to tighten up the fence ?

I know it's been discussed before but I need the information again: Can batteries be left in the charger without damaging them. Thanks Bob

Is there a way to hookup my outside garage lights to come on when I use my garage door opener ( sears craftsman )

circuit breaker kicks out, label says " Garage lights " but I can't find the problem everything in the garage is operational, My question is How do I find the problem where is goes straight to ground, cannot reset the breaker - instantly goes to ground and ideas ? thanks

I would like to post a question about my well pump " I have low water pressure can I adjust something to do better " what section should I place it in ?

How high above the roof does the mast have to be, one said 2' above the roof and another says 1' above the peak, What does the national electric code book say ?

Small hunting cabin in Northern Michigan 500 sq ft, I have a wall mounted ventless 30,000 BTU heater, my question is will a 100# gas tank run this heater all weekend ?

Are the push in connectors any good they look fantastic ? things I should look for or things I should stay away from.

I am building a small hunting cabin in Northern Michigan and I am going to use a ventless L.P. gas for heat, My question is: can I run that flexible gas line or should it be copper tubing ? and what size tubing ? thanks Bob

while going through my wrenches I notice that there is a 15/16 combo wrench and I don't think I have EVER used it can anyone give me a idea what it might be used for ?

I have a truck cap and the clear coat is flaking off, what can I use to remove ALL the rest of the remaining clear coat so I can paint the cap the same as my truck. Thinner or paint remover ????????? thanks Bob

what is the best way to organize my screwdrivers and pliers, does anyone have a easy was such as holders or racks.