Search results

Attempting to get system laid out before I sweat all joint Confused what taco means by orient pump motor in horizontal axis? Can I rotate entire assembly? I have expansion tank. Anything else that im missing?

I have a 40x64 post frame building with metal sides, roof, etc and interior walls /ceiling finished in metal. I can't get a cell phone signal to save my life. Any type of booster I could add??

I have 8 loops on my floor heat system. When I layed them out i tried to stay between 275-300 feet per loop. Well that must not have worked out like I planned. My calculations read 1GPM per loop and 17 Ft of head. I'm using a TACO 009 pump. Im getting .25 gpm out of 2 zones which i remember are...

For you guys with a well insulated larger slab from a cold start how long for slab to get up to temperature?? 12 hours?? 24 hours??

Finally got around to complete my radiant in floor set-up after countless hours of researching various set-up on the site. New to this radiant stuff and hoping I did everything right. Building is 40x64x14 R-30 in ceiling with 6 inches of open cell on walls 2" XPS under 6" concrete perimeter...

Getting ready to install an outdoor wood burner to heat my 40x64 pole barn. 8 runs of pex in floor. Garage has 5" spray foam on walls, insulated garage doors, and r-30 in ceiling. Wood burner is 180,000 BTU. How often am I going to be filling burner if I keep garage around 65*???

In the process of adding ceiling and insulating pole barn ceiling. Trusses are 4' on center with purlins and tyvek wrap under roof metal. full ridge and soffit vents. Plan is to install 6 mill vapor barrier on bottom truss cords then wrap in white metal 33ft sections. As far as insulation I have...

Have a 40 x 64x14 post set every 8'. Noticed post splitting/ splintering length wise. Read this is normal with dimensional treated lumber. Anyone else have this problem?

How many plumb cold water lines IE sink toilet, etc. underslab before floor is poured??

How thick did you go?? 6 Mil, 10 Mil, 12 Mil, 15 Mil???

Been lurking for a while so I figured I'd join the community! Build is fairly simple. The two garage filled up rather quickly so I finally pulled the trigger on something bigger to hold a couple toys. Garage will progress as I get time and money! 40x64x14 All metal pole building 3 12' Doors 200...