Search results

I have been waiting for a spell of dry weather before applying my Ghostshield 8510 over the 4500 intensifier. Here it says to allow 12 hours before rain.... Do not apply when temperatures are expected to fall below 32°F within 8 hours or when rain is expected within 12 hours following...

This week I put on a coat of Ghostshield 4500 . I diluted it at 4:1 as recommended here and applied a single coat of this intensifier with a backpack sprayer and I smoothed it out with an 18 inch flat microfiber floor mop to avoid any puddling. I used a little less than 4 gallons on a 2100...

I have seen two different sets of instructions for the dilution of Ghostshield 4500 when using it as a concrete primer/ intensifier One set of instructions say to dilute 1 gallon of 4500 to 1 gallon of distilled water...

I recently got this keyless chuck. It comes with two spare o-rings. What are the o-rings for ? I can't figure it out. https://www.amazon.com/dp/B0DYK4K81T?tag=atomicindus08-20

Now that the warmer weather is here, I am intending to treat my 35 x 60 shop concrete floor with Ghostshield 4100 Intensifier and Ghostshield 8510. In order to get a better oil resistant finish, can I then apply a coat of TS210 over the fully cured Ghostshield or is this not possible ?

I am getting ready to treat my new 35 x 60 shop floor with Ghost Shield 4500 and then 8510. I wanted to use TS210 but I don't have adequate temperatures left this season. Should I fill the expansion joint cuts ? I see Silkaflex recommended or is there something better ? Should I fill before the...

I am getting very close to treating the machine floated concrete floor in my new 35 x 60 shop. I am considering Ghostshield 4100 densfier and then a coat of 8510. The other option that I am considering is TS210. I have bought the 4100 so I am leaning more that the way but I don't know if the...

I recently installed a 35 x 60 metal building. It has five 12 foot roll up doors. The doors are set back about 6 inches from the edge of the concrete slab. I have been having problems with water getting under the doors. I now realize that the problem is the six inch deep concrete porch in front...

I am looking to install twelve 8 foot LED lighting fixtures in my new 60 x 35 shop. I have looked at the Barrina lights on Amazon but I am seeing that they can cause RFI (radio frequency interference) which can interfere with wireless door openers and the FM radio. I will have both in my shop...

Upon advice, I am planning on treating my new shop's concrete floor with a densifier 4500 first then Ghostshield 8505 or 8510. I am planning on having a 2 post lift installed. Should I treat the floor with densifier before or after the 2 post lift is installed ? Will the intensified floor...

I am looking at the Rotary SPO12 two post lift as I have read good things about it here. I am also considering the SPO12-Wide lift as well. Are there any disadvantages going with the SPO12-Wide if I have a big enough shop?

I wonder if someone can help me out by taking a measurement of their Benpak 2 post lift. I am considering the Bendpak XPR-10AXLS lift. The top will poke up above my shop roof trusses. This will work if I am careful not to lift a vehicle to high. I am concerned about the height of the limit...