Search results

I poke some holes in the bottom and side with an old center punch. You would be surprised how much oil stays stuck in them due to the anti-drain back valve.

I’ve had luck by parking on ramps in the driveway, then spraying the underside with some degreaser. After I let it soak for awhile I run the sprayer under at a few different angles. That has worked good for me on things that I can get spray to. Certain areas are always going to be obstructed and...

https://www.homedepot.com/p/RYOBI-Pressure-Washer-Water-Broom-RY31211/300701617 I have one of these and you can use it facing up or down.

You should buy some stuff from Zoro. I love that place, but there are no Tetris champs in their warehouse.

You can check out this thread. https://www.garagejournal.com/forum/threads/power-drawer-for-non-snap-on-boxes.351706/

Slightly off topic, but what is a good (reasonably priced) TPMS tool for the DIYer? Specifically I have a 2008 Honda Odyssey I need to get working.

I’m looking for ideas on how to store some wood in my garage. The things I‘m dealing with are half a sheets of plywood, some 2x4s full lengths and pieces, chunks of 4x4s, etc. Basically things leftover from a specific project that are too big to throw away, but have a tendency to take up a large...

I have an old Craftsman box where the plastic hinge broke. I used a piece of strap and some rivets. It’s been like this for over a decade with no issues.

Proto makes a nice made in USA version if that matters to you.

I’m curious about your cooling plan? I’ve never had a garage were the heat wouldn’t have been a major issue.

One that I haven’t seen in the list that I find interesting is Stumpy Nubs woodworking.

I like the Diesel Creek stuff.

Does anyone make long extension sockets like Gearwrench 84980, but in 1/4“ drive?

I bought one for the garage and it has migrated into the house. It is used everyday for spot tasks (I have little kids). I have a 4.0 battery on it and it lasts forever. Way better than the dirt devil with rechargeable battery that it replaced. I have contemplated getting a second M12 to...

I got a good deal on some Knipex pliers from their website. They were sold by Walmart, not 3rd party.

I‘ve had a Suncast for 8 years in the hot AZ sun and the shed itself has done fine. The only issue I’ve had is the plastic bolts that hold it together get brittle and break. They are a weird metric thread so finding replacements outside of suncast is difficult. I think the key is solid level...

I bought something from the online store, don’t recall what off the top of my head, but there were no issues. I‘d buy from them again if I need something they have for a good price.

If they were hotter than the surface of the sun.

I once got a negative feedback of “way over priced - items too small.” The item was a new sealed DVD for $5 shipped. The buyer never contacted me to explain what it even meant and eBay wouldn‘t remove it.

Is there a non-destructive way to remove this type of press on wheel nut? If there isn’t what’s the fastest way to get them off?