Recent content by zfrank07

with the lights being on the underside of the trusses and i cap off about the trusses, i think i would run into problems fitting the osb boards where my trusses are braced from the highest point.

i have looked at how i would go about capping off ceiling and i think i would rather put the insulation along the roof line, dont mind heating the peak.....with this being a small garage 24x24 with 8 foot walls, there really isnt much space in the peak.....so how could i insulate along the metal...

board on top of the trusses? like in osb sheets? would that look alright with the trusses being visable,right now my lights are directly on the bottom of the trusses

in my newly built 24x24 garage i have the walls insulated with osb board on the interior ...my ceiling is open.. but i have my lights mounted on my trusses. it has metal for the roof. how could i insulate the ceiling without closing in where my lights are which would be 8 foot from floor since...

for my detached garage, if i go with fiberglass insulation after dropping a ceiling in, what r value should i go with? location is kentucky, if that matters...garage is only 24x24

alright so i have a 24x24 garage with 8 ft walls....walls are studded and insulated with r13. the ceiling is open, with metal roof. How should i go about insulating the ceiling...should i close in the ceiling 8 ft up along the bottom of trusses. and put the insulation in between the trusses or...

alright i just bought a 60k btu reddy heater at a local auction...its like brand new...But i got it home and i dont have any fuel but i plugged it up and turned switch on and bout 5 seconds the fan and stuff starts blowing then it stops.... is this what its suppose to do with no fuel, just...

any know the cowt kilowatt hour here in central kentucky? i have KU electricity

wiring of this heater? would i needto just wire it to 220 plug? on a 30 amp breaker? or wire it straight to the breaker? if its straight to the breaker can i turn it on and off, i dont want it to run all the time! also what is the cost of operating this unit? i will be heating a 24x24 garage 8...

ive been lookin at the same heater...im wondering what it would cost to use the electric heater? like with it always on to kick on and off at certain temp vs. just using it on weekends or whenever working in garage?

i am stuck between a torpedo heater or http://www.heater-home.com/product/PH-5HW.aspx or http://www.heater-home.com/product/G73.aspx my garage is 24x24 8 ft walls...which are insulated.. roof will soon be insulated. which would be best for me to heat my garage? and if torpedo heater, what...

i am stuck between a torpedo heater or http://www.heater-home.com/product/PH-5HW.aspx my garage is 24x24 8 ft walls...which are insulated.. roof will soon be insulated. which would be best for me to heat my garage? and if torpedo heater, what size? i like to keep it warm.....

http://www.heater-home.com/product/U31.aspx how would this heater in this link do in my garage? it is the dayton U31 Portable Electric Radiant Convection Space Heater

so would a kerosene torpedo reddy heater do the job? what size would i need to get it as warms as a person would like and maintain for say a whole day! or should i go with a ceiling mounted infared heater? if i go with the infared heater, would i have to run lines to the exterior for the...

i am located in kentucky. walls are insulated...roof isnt insulated, havent figured out the best way of insulating it, i dont want to put a ceiling in it, i want to leave the trusses open. money 300-500 bucks the most. no natural gas or propane tanks on property right now.