Search results

I'm planning on burying a 55gal plastic drum for my shop drain outside of my shop. I'm planning on getting the top of it 14-15inches below grade. So I'm assuming my 2in pvc will be around 12-14 below grade coming out of the shop. Any issues with driving a small utility tractor over it in the...

So I have a 38x58 shed. Half divided and was finished by previous owners. I have since tore down the divider wall and planning on pouring more concrete. As of now there is 38widex27deep left to pour. I plan on pouring 38x18 this year leaving the last 9ft for next year when I plan on adding a...

So part of my post frame is finished and separated with a wall. I plan on ripping the wall down making it one big area. The fished side the ceiling joist are 16 on center with 2x4s. I belive 8ft between the rafters but need to double check. Plywood ceiling. Should I continue using the 2x4 or...

Right now my 40x60x10 is divided in half ,finished and cold side.Looking to finish the cold side of my shed and tear down dividing wall. Previous owners did not install tyvek under tin. Debating between doing just fiberglass batts or of doing 1in foam board then fiberglass batts in walls. Walls...

Has anyone bought a "bladeless" fan from amazon. I've been looking at them to add them in our bedrooms in mobile home we have at the lake. The ceilings are low and these look like best option. Right now there are either a single light with pull string or a light with a twist switch which...

We are in the process if remodeling our kitchen. I need to install a dishwasher and also a garbage disposal as it previously didn't have either. Can I use the same outlet for both of these Also at What height would I install the outlets for each.

So we have one kitchen light that is controlled by a 4 way switches. we would like to add 2 drop down pendant lights that are controller at the same time with this light but that would mean opening up half our ceiling to run wiring. Is there a way that I can connect to the nearest 4 way switch...

So right now we have 2 heat runs into our bedroom which is 192sq ft. We want to expand a doorway downstairs but one of the registers is in the way that feeds our room. How many would remove the heat run to go forward with making the doorway bigger. It would make the doorway between our living...

How hard would it be to move this heat rub to the next run to the left. Upstairs above this is a closet so I could cut floor up. Our plan was to expand the doorway until we ran into this issue.

So we decided to remove a pocket sliding door and then continued to open up the wall without doin to much investigating. The second pic is tye floor joist below. Haveing the 2 joist nailed together u der the wall has a but worried its load bearing. The floor joist and wall are running the same...

Is anyone usong these lights from amazon? Looking to replace the lights in my 38x58 with these. Almost aeems too cheap to be good but the reviews all look great from what ive seen. hoping someone on here has first hamd experience with them

So our house has 2 doorbells. The front one was hooked up to a camera that functioned correctly. Tonight I tried hooking up one one the rear door. Some how I managed to knock out the power to the front door and now I have no power to either door. Any quick help on which wires would go where on...

Right now I have a 16ft sliding door on the gable end of my pole building. I plan in changing to an overhead garage door. Might be a dumb question but Do I need to use a Lvl or can I get away using a 2x8. I think I already know the answer, but a 16ft lvl is special order locally

So I'm going to be framing a room in our basement (under our 4 seasons room). The room is 15x12. Basment walls are poured. The room will be mostly for storage (hunting equipment) but I plan on finishing down the road. My question is what's wvwryones thoughts on moisture barrier behind the...

Has anyone found a lighting solution for downlights when you have no soffit. I have about 6 inches of roof overhang but no soffit on my pole building. I have motion lights on my gable ends up nothing on the end walls (60ft). I would like to add some sort of lighting but can't really find...

I know this is kind if vague question but I am looking for a 13in deep 18ish wide gun safe. Height isn't a big deal. I'm trying to fill a void in a closet that will be hidden and trying to use up the space avalible but I'm struggling to find a safe roughly that size. Didn't know if anyone had...

Getting new internet hooked up in our new to us house. Provider will be CenturyLink (unfortunately only one available) my pole building shop is 100ft from the house. And would like to get wifi out there Would a mesh system work for my situation ? Never used it before and some research has led...

We are in the process of buying a new home. Shop is 100ft or so from the house. Need to have internet in the shop and curious what the best /easiest way to get it out there will be. Previous owners said they already have a landline out there. We plan on goin with CenturyLink as a supplier...

Were in the process of buying a new home. Thinking of buying a paint sprayer. We are wanting to paint the kitchen cabinets and trim. Was hoping to stay under $250. Any recommendations or things to watch out for in a sprayer. Never used one before

What would be the easiest and cheapest way to get audio from my tv to my stereo reciever on the opposite side of my shed. Dont really want to run cables 50ft Didnt know if there was a cheap way to send signal wirelessly but not break the bank Sent from my SM-G930R4 using Tapatalk