Search results

I haven't gotten the pressure gauge yet, but I replaced the solenoid, plunger and gasket. Easy to replace. Appears to work properly now.

It's a hell of a lot easier on the 3.5EB than it is for the 3.5NA. You need to remove the top half of the intake on the NA.

Tonight was doing an oil change and tire rotation on the 2016 Explorer Sport.

Sunday.... Replaced the Fuel Vapor Separator Valve/Tube Assembly on the 2018 Ford Edge 2.0EB (5) tube connections and (1) electrical connector. 3 hours total, with 2 hours of that trying to get the one hose retainer clipped into place. Needed to fabricate a retainer clip to allow me to slide...

Time to buy another tool...

I don't have a way to measure it.

upper Regulator REGO LV4403B66 outlet pressure range 9-13 InWC

LP VAPOR minimum inlet pressure 5 InWC maximum inlet pressure 14 InWC maximum flow rate 481042 BTU/HR

Good Morning All, I have a Generac RG03824 Generator and was having Over-crank Errors (1100). In June of 2022, the Generator Co I am using for maintenance replaced the 0F5022 Fuel Regulator Shutoff Solenoid with the larger 0J7137. It worked fine for about 9 months and now the Overcrank Error...

DCEN?

How far is the run from where it comes off the pole to your weatherhead? I'd run conduit from that pole to the house, with a new meter base.

Installed new rear pads and rotors on the 2018 Ford Edge SEL.

That is what I was wondering....could also be a loose connection or wire broken within the insulation? Also, that thermostat appears to be obsolete, so getting a compatible replacement might be challenging.

It functions normally 99% of the time. It just flakes occasionally, this time it flaked twice in a weeks time. I'm just trying to understand the operation of the controls on this heat pump & figure out why this POS flakes out occasionally...... because I am an Engineer :)(or should I say have a...

The York S1-TTSCC02 shows compatibility with: CZE, CZF, CZH, YZB, YZE, YZF, YZH, YPLC, YP9C, TM9V, TM8V, MV, AHV

I don't see anything like this, unless it is installed inside the air handler.... The entire system was "spec'd" as a York Affinity System.

Interesting, this is what the builder's HVAC guys included with the "upgraded" Heat Pump. Where would that interface module be hiding?

Greetings I would like to better understand how my Electric Heat Pump operates on the control side. For instance, does the indoor/outdoor units have 'brains' in them or is all the control accomplished via the thermostat? Twice over the last week, my HVAC failed to operate in the morning. The...

My caution to using these reels, is not to keep too much cord on the reel if you are using something that is pulling higher amps. The coil becomes an inductor. A few years ago, in my old house before I finished the basement, I had one of those oil filled heaters in the coldest months. One day I...

Wishing you a good outcome, Welder4955🙏