Search results

Can a amp clamp on a multimeter be used to check if an engine is getting spark

Thinkdiag OBD2 Scanner Bluetooth, All System Bidirectional scan Tool OE Level Diagnostic Tools with ECU Coding,15+ Service Functions All Software 1 Year Free fits for iPhone & Android https://www.amazon.com/dp/B08YWTJY4F/?tag=atomicindus08-20 I need to calibrate a replacement air bag PPM I...

Who manufactures the sockets that are labeled crescent is possibly Infar or Gedor

Looking to add to my tools who's better wrenches and sockets icon or Capri also has anyone used the wave drive wrench set do they grab as good as the RBRT stuff

Should I buy the XL ratcheting box set metric in tekton I like that they are 6 point or icon that I have read is the same as the Malco set

Does anyone know where I can get 1" Red heat shrink tubing . Every place I order from seems to show up and it pink. I need red it will be used in a visible location

So I took the handle off the ratchet because I hated it . It is seems I like it this way would it be crazy to use it like this. Sent from my SM-T560NU using The Garage Journal mobile app

I have a small ramp at my garage door I don't know if I can just slice it there and it will lay down or if there are any other ideas The ramp is about an inch at deep point and about 2.5 feet long

http://www.popularmechanics.com/home/tools/news/a18441/harbor-freight-drill-master-recall/

Im in buffalo ny area is home depot best price I'm gonna get on insulation or does anyone know of a better place

I recessed troffer lights between my rafters and boxed out the sides my question is can I use rigid foam above the lights to box it out and provide some insulation The units are not ic rated and the rigid foam would not touch there would be about a 3" space

Switched from stupid metal chair to these car seats much more comfortable gotta paint the bases and stuff but it is an upgrade

I bought a 5000 watt comfort zone heater the instructions say hard wire but I have a 10-30 nema plug I would like to use could I use a 10 gauge drier cord and wire it so I can plug it in or will this cause a problem

Please tell me anything at all thats not right EDIT: Flipped and attached the original picture.. ..Eric

Can I run my wires to the ground and neutral bars this way or do they have to face the other way

Can I put two 12-2 cables under these staples

Does this panel look like it's set up right for a detached garage subpanel I am gonna us the bar that's bonded to the panel for ground

When I ran my 6-3 thru the LB I got couple spots like this it like a dent it does not go thru the outer gray covering it just like it got pressed to hard in the fitting

I know I need sch 80 for the stub outs for my sub panel but do I have to find a sch 80 LB or will the sch 49 home depot has work

I am running 6-3 ufb from home to garage for subpanel. What connector is correct for when it enters the panel