Search results

I am trying to find some 4' x 18' x 1/8"-1/4" thick rubber to use for a seal above a garage door. Ant idea if any stores sell something like this? Thanks

I need to change the ballasts in my 12- 8' - 4 bulb (4' bulbs) to residential type so I can get radio reception. Where can I purchase these at a good price? Thanks

I had a Morton shed built, and the door leaks. Morton has been out 3 times, and finally said its because the threshold is attached to the cement and no more adjustment can be made. The bottom left of the door is higher then the bottom right side. I think I can also feel a draft around the...

I am building a Kitchen Island for my shed. I plan to use 2 - 30" wide base counter height cabinets, and am trying to decide on the table top size. I am thinking 4' x 6'. Does this sound like a good size? I also plan to use the newer high definition laminated counter top. Thanks

I am looking to add some basic kitchen cabinets and an island in my shed. No sink, or water, just cabinets for some storage, counters to work on, and an island for larger projects and to sit and eat at. Where should I go to price something like this, I don't need fancy. Thanks

I am installing can lights in a new basement and want to make sure I purchase the correct type that I need. I was also told some LED fixtures don't fit in drop ceilings all the time nice and flush. Any advice?

Are these any good? Thanks for any feedback.

I have a lot of half dead fly's in my new shed...interior is finished. Any idea *********** them and prevent them. I just had it insulated, not sure if they were in that? Thanks

I have rspace in my shed for a lounge area/tv area in my shed. Does anyone have any pictures they can share for ideas on how to arrange stuff? Thanks

I have a well insulated 30x40x12 pole shed I am trying to buy a Natural gas hanging garage heater for. What the best size I should get. I live in southern WI. Thanks

First...why is it so bad? Second, can a car antenna be hooked to a one wire fm antenna to improve reception? I tested 3 radios, and all worked fine in my brick exterior garage, but in the metal pole shed, it kills it to about 25 percent reception. Basically I get 2 stations, but both have...

For $450 I can buy a Beacon Morris or a Mr Heater 75k gas garage heater. Or for $850 I can get either a Reznor or Modine. Are they actually any better. It sure seems like they are all made the same. Thanks

I am installing a metal wall liner from menards. How should I trim out the breaker box so it looks nice? Thanks

I purchased metal interior wall liners for my shed....went to install and somehow they are in inch too short. I was also using a bottom trim piece. Any suggestions? Thanks It goes...J trim at top, then the 11'6" liner, then bottom trim. Between bottom trim and cement I will have a 1" gap.

Doing the interior walls in my shed with metal...whats the best way to cut the trim strait? Thanks

Should I use a base board? If so what is something good to use. I thought about composite decking, then putting metal base trim on top of that and then putting the wall liner panels above those two pieces. I was thinking having a base board would be nice to sweep up against and more...

Can someone tell me how thick these 2 usually are? Thanks

What's the best trim to use for around doors, corners, and on the floor? thanks

It seems that the light that is included with the 8500 comes on by motion. Is it possible to program it so it only comes on when the door opens or closes, then times out and shuts off like most normal garage opener lights?

I will be starting to install a metal ceiling in my pole shed next week. My first question is, for J-Channel, what do I use to mount that stuff with. Screws or roofing nails? Thanks