Search results

Sounds more like a scam/publicity stunt. Not sure why they are doing it, but if you look at the terms they are not giving you much time to empty the store, if they even let you get that far: Pick Up Date: Friday, May 17th 2024 from 9:00 AM to 3:00 PM local time Pick Up Notes...

Thank you for all the feedback. I will look into Zenni and Walmart.

Work has implemented a mandatory safety glasses policy when on the shop floor. My current prescription glasses will not accept side shields, so I need to purchase a new pair of prescription safety glasses. I see a large variety of safety glasses companies online, has anyone had a good...

Mike, Do you put anything on the headlight housings after you polish them? I've seen some products from 3M that are supposed to help with sun damage after cleaning.

Thank you for the information.

I run my trailer over some rough rocky terrain and have experienced a few flats. In an effort to try and catch a flat before any tire damage is done I am looking at aftermarket TPMS systems. Does anyone have a positive or negative experience with these types of systems? Thank you for the help.

Slow Loading of pages. It takes a long time to load pages. Most of the time when I am trying to scroll down it will pause for several minutes. In the lower left status line it usually shows waiting for some type of "lick add". How can I stop this from happening? Update : status in lower...

If you decide to use plastic again compare the coefficient of thermal expansion (CTE) to the HDPE you have already tried. If the new material has a CTE similar to HDPE you will have the same issue. The HDPE might work but you will need to change how you mount / restrain it. The panel will...

See if ARP has something close.

Thank you for all the feedback.

Thanks for the reply. I washed everthing with baking soda/water mix during cleaning process. Is there a better way to neutralize acid?

I have been having a corrosion issue with the batteries on my 2017 F250, factory 2 battery set-up. I have removed the battery terminals and cleaned them, removed all the mounting hardware stripped and repainted, and coated everything with battery corrosion protection spray. 6 months later the...

Exmaxima1's solution along with allowing the table to swivel will also reduce the torque created when trying to lift the table at one point in the rear.

dr_clyde - Want to keep the cost under $40k. This will be used in a commercial setting.

I am looking at buying a 4'x8' CNC router with a tool changer. I will mainly be cutting plastic, wood, and thinner aluminum. Does anyone have experience with routers that can help with brands or features to look for or avoid?

Is the lens glass or plastic. If plastic you could scuff it with sandpaper or scotchbrite, if glass you could etch it with various techniques.

I had a similar issue with my shop/garage in NC. It is insulated which kept it at a different temperature than the outside, hotter or cooler depending on the day. When I opened the 16' garage door and let in warm moist air, water would condense on the cooler objects inside the shop (lathe, mill...

The soap injection keeps bypassing and I loose pressure.

I have a northern tool pressure washer. I want to delete the soap injection on my pressure washer. There is a tube that runs between the water inlet and the pressure outlet that bypasses the pump. Does anyone know what this line is for?

For future builds to minimize the tube pulling when welding do not weld across the face of a tube. Weld the two sides that run parallel to tube.