Search results

I have an early Delta 15" DP that I need to put on a mobile base. I picked up a Shop Fox heavy duty that will easily handle the weight. My question is how large do I make the base? I'll be putting a couple layers of 3/4" ply underneath and not sure if I need to add a few inches all around for...

What's the going rate for a Benchmaster vertical mill? Thanks

Does anyone have a source for an after market slow-speed pulley setup for a Delta DP 220? Thanks

When I was a kid my father would take the cans of oil he just put in the car after a change and let the remainder drain into his oil can. Every day, he'd change the can until the five cans were completely empty. When I needed to squirt some oil on my bicycle chain it was 10 W 40. My question is...

I'm about to add some dust collection to my Unisaw and need suggestions on cutting a 4" hole through the steel for the dust port. My original thought was to use a jig saw but the saw will remain in its upright position and that method would be awkward. I decided to go on Amazon and see what's...

I have a parts lathe that I would like to finish parting out. If anyone needs anything pictured, let me know and we'll work out a price plus postage. A few notes; the motor pulley on the countershaft is badly chipped, the hand wheel on the tailstock is missing.The carriage assembly, spindle...

I purchased a set of rails for the bandsaw last year and this fence came along with it. It's missing parts but I thought someone might be able to use the remaining parts. Just cover postage and you can have it.

I picked up a Delta 15" variable speed drill press with a production table last fall. Question, how do you attach a vice, etc. to the table as it has no holes?

I'd like to change out my Delta 1460 lathe from the jack shaft to a 3-Phase VFD setup. When I go to sites like Grizzly and look at the specs for the lathe motors they're rated at 1725 rpm. No doubt this is a silly question but how do they achieve a top end spindle rpm of 3200?

I'm installing the motor that I just put fresh wires on and it's a little crowded coming out from under the cover plate. There's an open hole in the motor casing and I'm wondering if they make a right angle fitting similar to the ones used in conduits?

Does anyone have experience replacing a worn out quill spring with a stock spring? Thanks

Recently picked up a Unisaw and the Delta mobile base. I added a cast iron router table to the wing and now the table is unsteady and could tip easily. I need to add a mobile base extension and naturally, Delta doesn't offer one. Anyone been in this situation and what have you done? Thanks.

Does anyone have any experience with this variable speed drill press......good....bad..?

I have a line on a 15" Delta Drill Press 15-107. I'm thinking it's a solid DP but I could be wrong. Any observations or comments would be welcome. Thanks

Has anyone tried mounting the Grizzly router table extension on an older Unisaw? The manual suggests removing a wing but I'd prefer to bolt it on to the wing. Anyone have any success doing this?

I've recently picked up an older 6" x 48" w/ 9" disc sander on a pedestal. I've noticed the newer versions of this model have dust ports for the belt and disc. Has anyone had any experience using these dust ports and are they effective? If so, I'll look for them on Ebay or keep my eye out for a...

Can anyone identify this jointer?

I have a shot at a Craftsman/Parks 18" bandsaw in decent shape for its age. Question, is $500 a reasonable price? Thanks

Does anyone have experience using both the Delta or similar brand chisel mortiser and the drill press mortiser attachment. I have an extra drill press that could be utilized as a dedicated mortiser. I also have the opportunity to purchase a Delta mortiser at a bargain price. Opinions and, or...

I find myself in need of a spring assembly and spring housing knob for a Craftsman "Mohawk" drill press.